לנסות
http://www.sandisk.com/Assets/File/Downloads/firmware/e200fw01.00.12.exe Once you have downloaded the file, please follow these instructions. 1) Double click on My Computer so that you can see it on your screen. 2) Turn the player off. 3) On the top of the player is a Hold switch, move it to the right (toward the headphone jack) so you see Orange. 4) On the left hand side of the player is a Record button, press and hold it while connecting the player to the computer. Continue holding the Record button until you see a new icon under My Computer called 16MB FORMAT. Once you see that icon you may release the Record button. 5) Double click the file you downloaded earlier and run it. Follow all of the on-screen instructions, and when you get to the prompt where it asks you whether you would like to Format it, choose Yes. Once it is done, click Finish. 6) Disconnect the player and look at the screen. Several things will be displayed, and when you see Key Lock, System Shutdown, move the Hold switch on the top back to the left. 7) Turn the player on and watch the screen. If you see a Refresh Database Fail error, you will need to follow steps 1-7 again until you do not get the error. If it does not work the first time, it could take up to 3 times for it to work. it shows the following message : Aplication failed to read the version details http://forums.sandisk.com/sansa/board/message?board.id=e200&message.id=6911&query.id=36279#M6911 http://forums.sandisk.com/sansa/board/message?board.id=e200&message.id=3715&query.id=36279#M3715 To access Recovery Mode: -Make sure the player is off (if necessary, hold down the power button for 20 seconds to turn it off) -Move the hold button to ON (move to the right towards the headphone jack). -Hold the record button. -Connect the player to the computer. -Keep holding the record button till the "new hardware is ready for use" comes up, and then release the record button. Now you should have a 16MB drive in My Computer.
